- #1
asad1111
- 51
- 0
iam using atmega 32 and i want to use external 16MHZ crystal I have figured out the fuse setting for this as lowbuyte=0xFF and highbyte=0Xc9
what i cannot understand is should i set fuse bits before programming or after programming? because as i have specified external crystal as clock source if i set fuse bits before programming it will require external crytal to be programmed (iam assuming controller requires clock source to be programmed does it?)and if i set the fuse bits after programming how will i reprogram it?
Iam using a universal burner to programme atmega32
what i cannot understand is should i set fuse bits before programming or after programming? because as i have specified external crystal as clock source if i set fuse bits before programming it will require external crytal to be programmed (iam assuming controller requires clock source to be programmed does it?)and if i set the fuse bits after programming how will i reprogram it?
Iam using a universal burner to programme atmega32