Recent content by sgvaibhav

Hi,I wanted to know what is the difference between ANSYS Fluent/ANSYS and CATIA. And what purpose do both of these applications serve? Furthermore, does Solidworks compete with CATIA? (If so, then i can focus on learning only one of them instead of two).I am just confused if i should learn ANSYS...

Ok thanks a lot. Time to head to the panasonic spare parts shop.

Few years ago, there was some drainage problem, and some unauthorized servicemen had repaired it, who could have been careless with the re-assembly. Referring to 256bits diagram of Tub assy...

Hi, I have a top loading panasonic washing machine. It is an no agitator top loading machine – something similar like this type – http://www.automaticwasher.info/TD/AWJPEG/MODERN/2011/freewestinghous++11-19-2011-03-25-8.jpg. So now i don't know if i have a damaged bolt, or a missing washer...

I built some self made creative tools, which i will try digging inside to fish objects. Dont know how reliable they are or how good they will work... If my own DIY tools don't work, then this magnetic flux tool looks like my next option.

Sadly, I cannot find such a rod/stick over here in my country. Just remembered, there are some hopes to find magnetic stick in ace hardware. Time to check it out there.

Actually I had dropped some object inside my a/c vent / duct. I carried out some dis-assembly to remove the grille, however I need something, which is very thin, and long, something like a dipstick to put inside the ducts, and to fish out the object using magnetic force. Or what about...

Hi, Is it possible to permanently magnetize a car engine dipstick? If yes, what would be the easiest way to get it magnetized, such that it will be able to lift an (rusted steel) object which is about 10 grams or lighter.

oh that's okay :P... all i didnt want is the flame going back towards the gas cylinder and blasting the cylinder!

Consider this case. An LPG cylinder is used to provide LPG to a rubber pipe (3/8" diameter). If a regulator is attached to the cylinder, and the rubber pipe is just left open on the other side to let gas out, and a match is kept at the open end. Will the flame that is created at the open...

The thing is we are using automobile turbocharger to build our jet engine. So for start up, we will inject fuel (LPG) and at the same time we will spin the blades/shaft using compressed air. So the engine is up on airpower, and then we need to ignite this injected LPG to start the engine and...

Hi, We are building a turbojet engine / gas turbine engine for our graduation project. We were looking out for ignition system for the combustion chamber. The fuel is LPG (20% propane 80% butane) What can be the best way to ignite a spark to light the flame in the combustion chamber to...

Hi, Trying not to bump the thread, but this is the best place to ask. Consider this regulator http://www.newgaz.com/Products/Cat/International_catalogue_2012_BD_P.pdf Search "002810AC". Over there it shows outlet pressure 1-3 bar (14-44 psig). So this 3 bar represents 3 bar gage pressure to...

Assumption : no temperature drop. or obtaining the pressure at the beginning of the operation, when temperature drop is negligible.

I have a domestic LPG cylinder. Composition - 20% Propane and 80% Butane. Temperature - Around 30-35 deg C. I wanted to know the temperature of the gas inside the cylinder or in other words, if i take gas out directly from the cylinder without using pressure reducing regulator, what will...