Yup, it makes sense.
I didn't mean doing a bunch of single LEDs though, I meant along the lines of treating the LEDs as 3 volts instead of the 3.2-3.4-3.6 since the lone one seemed to work fine with the 3 volt battery pack. And then go with the x3 series stack you mentioned earlier with the 12...
I can see if I have another battery charger lying around somewhere. I also have a 30VDC 5A adjustable power supply that I can use to test things.
Would it be possible to just use lower voltage? I tried using a single LED with a two C battery pack and it lit up fine.
Sorry, I'm pretty new to this. I was mainly going off of the diagram on the link. I thought the 1 ohm resistor was just to keep the flow to the LED smooth? How should I change the circuit set up?
Hello,
I'm planning to light up a tile chess board with 64 LEDs (blue and white) set between the tile squares, and I was wondering if this Class 2 Battery charger output: 12VDC 900mA, would work to power 16 parallel sets of 4 LEDs + 1 ohm 1/8W resistor and a SPST toggle switch? The current...
Hello,
I came up with an idea, wen't through the steps and it consistently worked. So now I'm writing a paper on it to submit for publishing. Along with this being my first forum post this is my first paper to publish, and I'm also only in my undergraduate right now, so please pardon my...