Vibration Amplitude: Structure Withstands # of Cycles w/ X,Y

[chandran]

A structure withstands a vibration of amplitude x and frequency y for z number of cycles. How many number of cycles the structure will withstand if the vibration amplitude is doubled. How many number of cycles the structure will withstand if the vibration frequency is doubled?

 

[Gokul43201]

There is no numerical answer to such questions. given the lack of description.

The number of cycles to failure (N) is related to the cycle amplitude through an exponential relation [itex]N = A \cdot S^{-k} [/itex] which is typically plotted as a linear fit on a half-log plot, known as an S-N curve. (google "S-N curve fatigue" and look at images). The exponent in the relation is highly material dependent. Also, this behavior is only one possible kind of fatigue known as high-cycle fatigue (where loading is essentially restricted to the elastic regime). If stresses, are much higher (into the plastic regime), you have low-cycle fatigue, for which the cycles to failure (N) is related to the amplitude of plastic strain (again, by an exponential plot), and you can not relate this to a stress amplitude without a stress-strain curve.

The actual frequency does not enter into S-N relationships, to a first order approximation. I expect, it will only enter as a factor (a term in the exponent) of the same order as the strain rate sensitivity index.

Moving this to Materials Engg ...

 

[ravenprp]

If the vibration amplitude is doubled, the structure will likely withstand half the number of cycles, as the increased amplitude will put more stress on the structure. However, the exact number of cycles the structure can withstand will depend on the specific properties and design of the structure.

If the vibration frequency is doubled, the structure may be able to withstand a similar number of cycles, as the increased frequency may not necessarily increase the stress on the structure. Again, this will depend on the specific properties and design of the structure. However, if the frequency is too high, it could potentially cause fatigue and shorten the lifespan of the structure.