Uncharging RLC circuit, critical & overdamped case

In summary, when a non-driven RLC circuit discharges, there are three possibilities: underdamped, critical, and overdamped. The general solution for the differential equation is Q(t) = A*exp(L1*t)+B*exp(L2*t), with L1 and L2 being roots of the characteristic polynomial. In the critical case, the characteristic polynomial has only one root, while in the overdamped case it has two. This results in the charge in the circuit decaying slower in the overdamped case compared to the critically damped case. The underdamped case decays the fastest, but also has oscillations before reaching a final DC zero. Therefore, the critical case is the most efficient in terms of reaching
  • #1
wimvd
4
0
When a non-driven RLC circuit discharges you have several possibilities: underdamped, critical & overdamped. The general solution of the differential equation is Q(t) = A*exp(L1*t)+B*exp(L2*t) with L1 and L2 roots of the characteristic polynom being (-R+sqrt(R^2-4*L/C))/(2*L) and (-R-sqrt(R^2-4*L/C))/(2*L)
In the critical case R^2-4*L/C is zero, in the overdamped case it is larger than zero.

Now in class we were told that in the critical case the charge always approaches faster to zero than in any overdamped case. I tried to figure out why but I don't seem to find the answer. I thought it had to do with the fact that in the critical case the characteristic polynom only has one root and in the overdamped it has two but I can't seem to find any mathematical proof of the charge going faster to zero.

If anyone has an idea as to how to prove this, it would be most welcome. :)


Thanks.
 
Physics news on Phys.org
  • #2
You're sort of right, but I'm not sure you understand why you're right. Consider the critically damped case. There is a double characteristic root of -R/(2*L), and so the circuit discharges toward zero at some rate.

Now consider the overdamped case (you can simply adjust the capacitor to a larger value to obtain this while keeping R and L constant)... you then have two roots: one of which is more negative than -R/(2*L) and one that is less negative than -R/(2*L). The charge over time will then be the sum of two decaying exponentials, one that decays more fast than e^(-R/(2*L)) and one that decays less fast. The one that decays more fast will die off quicker, but after that point the charge in the circuit will be governed by the exponential which decayed less quickly, therefore the overdamped case will always decay slower than the critically damped case (assuming you are just adjusting capacitances).

Edit: Minor correction. You don't have the restriction of leaving R and L constant to prove my point, you just need to have -R/2L as a constant to maintain the ratio.
 
Last edited by a moderator:
  • #3
And keep in mind that in the underdamped case, the charge on the cap reaches zero faster than in the other two cases. But then it keeps on going negative, turns around, crosses zero again, etc. as it damps out to a final DC zero coulombs. The critically damped case gets the charge on the cap (and hence the voltage) to zero the quickest for the case where it does not swing negative.
 

Related to Uncharging RLC circuit, critical & overdamped case

1. What is an RLC circuit?

An RLC circuit is an electrical circuit that contains a resistor, inductor, and capacitor. These three components are connected in series or parallel to form a circuit that can store and release electrical energy.

2. What is uncharging in an RLC circuit?

Uncharging refers to the process of dissipating the stored energy in an RLC circuit. This can occur naturally due to the circuit's internal resistance or can be intentionally induced by adding a resistor to the circuit.

3. What is the critical case in an uncharging RLC circuit?

The critical case in an uncharging RLC circuit is when the circuit is neither underdamped nor overdamped. This means that the circuit reaches its equilibrium state in the shortest amount of time without any oscillations.

4. What is the overdamped case in an uncharging RLC circuit?

The overdamped case in an uncharging RLC circuit occurs when the circuit has a high amount of resistance, causing the energy to dissipate slowly. This results in a longer time for the circuit to reach its equilibrium state without any oscillations.

5. How is the uncharging process affected by the initial energy in the circuit?

The initial energy in an RLC circuit will affect the rate at which the circuit uncharges. A higher initial energy will result in a longer uncharging time, while a lower initial energy will result in a shorter uncharging time. However, the final equilibrium state of the circuit will remain the same regardless of the initial energy.

Similar threads

  • Introductory Physics Homework Help
Replies
1
Views
196
  • Introductory Physics Homework Help
Replies
5
Views
336
  • Introductory Physics Homework Help
Replies
8
Views
1K
  • Introductory Physics Homework Help
Replies
3
Views
2K
  • Introductory Physics Homework Help
Replies
3
Views
2K
  • Introductory Physics Homework Help
Replies
14
Views
2K
  • Introductory Physics Homework Help
Replies
3
Views
803
  • Introductory Physics Homework Help
Replies
5
Views
246
  • Introductory Physics Homework Help
Replies
3
Views
1K
  • Introductory Physics Homework Help
Replies
2
Views
1K
Back
Top