Exploring the Nitrogen-Powered Plane Prototype: Insights and Challenges

In summary: It doesn't seem like it would be too difficult to make a high-pressure tank, but it's definitely an engineering pain. Compared to nitrogen, it has a much lower energy density.
  • #1
Cheesus128
22
0
Hey,
I saw a documentary about the first Nitrogen powered plane.
It was being developed in Germany and is more a prototype than anything else.
They said one of the problems is that the tank is insanly expensive for liquid nitrogen but "Cheap" for nitrogen gas.
Well I don´t understand why it is so expensive and why they need to insulate the tanks. I mean considering you kept the liquid nitrogen under preasure it could not turn into gas until it is being burnt.
Am I right?
 
Physics news on Phys.org
  • #2
If you don't insulate the tank you end up with a plane covered in several tons of ice.

ps - Are you sure you mean nitrogen and not hydrogen?
 
  • #3
Wait so the Air around the tank would freeze too?
 
Last edited:
  • #4
Nitrogen boils (at standard pressure) at 77K, Hydrogen at 20K
At normal pressure neither of them will form a solid, you can make solid N2 and H2 under vacuum - you use this for cooling camera below 77K for example, but it's an engineering pain.
 
  • #5
If it is nitrogen, the air around the tank wouldn't freeze, but it would collect lots of water vapor.

A nitrogen plane would use compressed air motors to turn propellors, wouldn't it? Hydrogen could be burned in jets.
 
  • #6
mgb_phys said:
Nitrogen boils (at standard pressure) at 77K, Hydrogen at 20K
At normal pressure neither of them will form a solid, you can make solid N2 and H2 under vacuum - you use this for cooling camera below 77K for example, but it's an engineering pain.

Nitrogen freezes at 63 K at standard pressure, hydrogen at 14 K. You might have been thinking of helium, which only freezes at higher pressures (assuming you misspoke by saying vacuum, which makes very little sense in this context).

A nitrogen powered plane seem very unlikely. The energy density of compressed nitrogen is pretty pathetic even compared to alternatives like batteries, which struggle to be useful for transport here on the ground. Liquid nitrogen might be a bit better, but will require heat exchangers to boil the nitrogen, which will be heavy and ice-prone...it'll also be relatively energy-intensive to produce. Such a vehicle might fly, but it won't be anything that'll actually see wide use.

Also, liquid nitrogen tanks are cheap, a styrofoam cup can be used for working with nitrogen, but a high-pressure gaseous nitrogen tank would be both expensive and heavy. This isn't so for hydrogen, it's deeply cryogenic enough that you need special tanks with sufficient insulation, made of materials that can handle those temperatures, etc. Aside from some material compatibility concerns (avoiding hydrogen embrittlement), a high pressure hydrogen tank is just like one for nitrogen, oxygen, or air. Plus, hydrogen has rather higher energy density than liquid or compressed nitrogen. I also suspect this was a misunderstanding of a hydrogen powered aircraft project.
 
  • #7
Algr said:
If it is nitrogen, the air around the tank wouldn't freeze, but it would collect lots of water vapor.

A nitrogen plane would use compressed air motors to turn propellors, wouldn't it? Hydrogen could be burned in jets.

Interesting factoid: A nitrogen line at the boiling point of nitrogen (77K) can liquefy the oxygen out of the air (BP 90K). If this occurs upon reducible substance, it can represent a significant fire hazard.
 
  • #8
Oxygen has a higher boiling point then nitrogen? Why does everyone use nitrogen for cooling things then? Is liquid oxygen really corrosive or something?
 
  • #9
Algr said:
Oxygen has a higher boiling point then nitrogen? Why does everyone use nitrogen for cooling things then? Is liquid oxygen really corrosive or something?

This is wandering off topic but basically nitrogen is relatively safe. It's already in air (78 percent or so), so obviously nontoxic to breath. Oxygen in concentration would cause a lot of fires set off by a small energy spark. Oxygen is very reactive. Nitrogen isn't. Remember the historic http://en.wikipedia.org/wiki/Apollo_1" ? However, nitrogen can displace the oxygen in the air, and cause blackout and affixiation without warning, so regular use should require sensors.
 
Last edited by a moderator:
  • #10
Sorry I slightly mixed up thermodynamics and engineering there.
You can cool N2 and H2 to a solid, but you would need extra cooling in place, you can easily solidify both by just pulling a vacuum but if you just need to store them it's not worth the extra effort over a liquid.

As Phrak points out -the reasons for not using liquid O2 are pretty obvious!
Even hydrogen has problems, it makes a lot of steels brittle.
 
  • #11
It's not that new of an idea. Some old free flight aircraft models used motors powered by small pressurized carbon dioxide cannisters.
 
  • #12
rcgldr said:
It's not that new of an idea. Some old free flight aircraft models used motors powered by small pressurized carbon dioxide cannisters.
This idea is to burn the hydrogen in either a fuel cell (to make electricity) or directly in a turbine not just use it as a water rocket.
Liquid hydrogen is currently the only thing that gets near to liquid dead dinosaur as a fuel in terms on energy density.
 
  • #13
rcgldr said:
It's not that new of an idea. Some old free flight aircraft models used motors powered by small pressurized carbon dioxide cannisters.
mgb_phys said:
This idea is to burn the hydrogen in either a fuel cell (to make electricity) or directly in a turbine not just use it as a water rocket.
I had seen one of these model airplanes once. Rather than using pressurized CO2 as a jet, it drove a small piston to rotate a propeller.
 
  • #14
Phrak said:
Rather than using pressurized CO2 as a jet, it drove a small piston to rotate a propeller.
Doesn't make a lot of difference, the total energy in a gas pressurized to 200bar in a 11L scuba tank is only about 1MJ - about the same as a tablespoon of jet fuel.
 
  • #15
mgb_phys said:
Doesn't make a lot of difference, the total energy in a gas pressurized to 200bar in a 11L scuba tank is only about 1MJ - about the same as a tablespoon of jet fuel.

That settles it. On my next dive, I'll use jet fuel. But seriously, it is a great deal more efficient, using the energy available, to push a lot of air a little faster with a propeller, than throwing it out in a narrow stream such as a jet. Of course, the compressed CO2 powered planes were surely a novely that didn't have a large market compared to burning nitro methane.
 
  • #16
Some dim memory of a thermodynamics lecture is that you have a maximum efficency of 66% for air expanding into a piston (can't remember if this is adiabatic) better than ICE but still not going to lift a 747.

There is a proposed compressed air driven car (french company le air-car?) which uses basically scuba tanks and a piston engine.
 
  • #17
rcgldr said:
It's not that new of an idea. Some old free flight aircraft models used motors powered by small pressurized carbon dioxide cannisters.

Phrak said:
I had seen one of these model airplanes once. Rather than using pressurized CO2 as a jet, it drove a small piston to rotate a propeller.
Which is what I meant by motors powered by the small CO2 cannisters.

Phrak said:
Of course, the compressed CO2 powered planes were surely a novely that didn't have a large market compared to burning nitro methane.
Free flight models only use a short burst of power, perhaps 15 to 30 seconds of power, then they glide in big circles. They needed a big field. There was no need for extended motor run times, so the CO2 motors were good enough.
 
  • #18
Mgb_phys: Yup, maximal efficiency of a Carnot cycle is somewhere around there.

It seems every so often, someone gets the (very unoriginal) idea of using compressed gas as energy-storage. It's an idea so old, it was old in the 19th century.
Yet somehow people seem to think they've found some way around the very obvious inefficiencies that stopped it in the past.

Now, find me some tetrahedral N4 (aka TdN4) and then we're talking some serious nitrogen fuel - Rocket fuel, even! An energy density of about 54 MJ/kg for its decomposition into two N2 molecules. No other components needed, and it's environmentally friendly too!
Just one slight problem.. We don't know how to make it. So far, it only exists in theory, although some http://dx.doi.org/10.1016/S0009-2614(01)00866-1" have been floated..
 
Last edited by a moderator:

Related to Exploring the Nitrogen-Powered Plane Prototype: Insights and Challenges

1. What inspired the creation of the nitrogen-powered plane prototype?

The nitrogen-powered plane prototype was inspired by the increasing need for sustainable and environmentally-friendly transportation options. Traditional fossil fuel-powered planes contribute significantly to air pollution and carbon emissions, and this prototype aims to provide an alternative that utilizes a renewable and abundant resource - nitrogen.

2. How does the nitrogen-powered plane prototype work?

The prototype works by utilizing nitrogen gas, which is compressed and stored in tanks onboard the plane. This compressed gas is then released and mixed with a small amount of fuel in the engine, producing combustion and generating thrust for the plane to fly.

3. What are the benefits of using nitrogen as a fuel source for planes?

Using nitrogen as a fuel source has several benefits, including reducing carbon emissions and air pollution, as nitrogen combustion produces mostly nitrogen gas and very low amounts of pollutants. It is also a renewable resource that can be easily sourced and does not contribute to the depletion of natural resources.

4. What are the challenges in developing and implementing a nitrogen-powered plane prototype?

One of the main challenges is the technology and infrastructure needed to produce and store compressed nitrogen gas. This requires specialized equipment and facilities, which may be costly to set up. Additionally, there may be safety concerns and regulations to consider when using a new type of fuel for air transportation.

5. What is the potential future impact of the nitrogen-powered plane prototype?

If successfully developed and implemented, the nitrogen-powered plane prototype has the potential to significantly reduce the carbon footprint of the aviation industry. It could also pave the way for other sustainable innovations in air transportation and inspire similar developments in other industries.

Similar threads

Replies
32
Views
3K
  • Sci-Fi Writing and World Building
Replies
21
Views
1K
  • DIY Projects
2
Replies
39
Views
8K
Replies
18
Views
3K
  • Electrical Engineering
Replies
4
Views
2K
Replies
35
Views
5K
Replies
31
Views
5K
  • General Engineering
Replies
19
Views
10K
  • Science Fiction and Fantasy Media
2
Replies
35
Views
19K
Replies
14
Views
3K
Back
Top