mfb, the reason I asked for contacts is because I tried too many vendors, but none of them can produce it.
I can't share the application, my client does not allow me to leak it, sorry
Thank you for your prompt reply, mfb and rumborak.
Do you guys have any reliable contacts to share, to purchase 2pcs of the abovementioned magnets, but at higher strength, 1.5T, minimum 1.0T?
Hi all,
I have two identical magnet which measures 0.6T when I put my gauss meter on the top surface. I configured the magnets as below:
I would like to know what should I expect if I measure the strength(Tesla)at the red round dot position? Would it be 1.2 tesla?
Please advise.
Thank you...
mfb,
Thanks for your prompt response. I was out of town last week and has got no internet access.
Last question I have here:
Will the sanwiched metal-dielectric-metal layer caused capacitive noise? If yes, is there any ways that I can eliminate them? Can I simply ground all metal plates to...
mfb,
Thank you for your prompt reply. Instead of PWM, I am using a steady current source. Therefore frequency is not high.
You did mention about absorbance of small fraction of EM wave by the metal plate. Will the absorbed EM by metal plate(connect to ground) be 'drained' to ground? Am I...
Dear all,
I am a newbie in electromagnetic wave. Can you educate me, what will happen when an electromagnetic wave is blocked by a piece of flat metal placed in front of it?
My intention is to build a thermal chuck using peltier for to measure femto amps from my device.
I am worried if...