Recent content by sedgehammer

Yes, that looks like I was looking for. Where can I buy it? Thank you!

I suppose so, but then I would need to make some sort of enclosure to keep it isolated. I was hoping to be able to use one that was enclosed already that had plugs on it or wire leads.

I just looked again and to me they looked like they are all soldering types for a circuit board. Of the few that might work, are 3 phase. Thank you.

I looked, most seem to be something for a circuit board. I need something with coated wire leads, as this goes under the truck cab and will be exposed to the elements to a certain degree. I'll use heat shrink butt connectors to connect. Thank you.

Yap, I just need to know what type of diode to get. Thank you!

Yes Tom, that is how it needs/is connected, thank you for the diagram! Now, what isolation diode would you recommend?

It has to be connected that way, but what I need is a way to stop the back bleed of power from the 2, 12 volt solenoid to the back up beeper.

I don't need to know when they are activated. I already know this when we lift them or they wouldn't lift. What i am needing is the backup safety beeper to not be powered when I power the 2, 12 volt solenoids to lift them.

Lol, your good. Perhaps I didn't explain it well. The beeper is just a safety device, to let anyone on the ground know that the truck is backing up and it can only beep when backing up. The beeper is activated via the reverse safety switch located on the transmission, when the truck is shifted...

I'm not so smart when it comes to electrical things, so please forgive my ignorance. Here's what I am trying to do. I have a quad axle dump truck, I'm trying to have the drop axles automatically come up when put into reverse. The drops are raised and lowered via 2, 12 volt solenoid valves. I...