Hi guys, I have finally gotten the L and C values:
The Ls are both 130mA and C1 and C2 is 0.1uF, and attached is an image of the circuit board.
Thank you,
sasg28
I am in the process of deciphering the L and C values, will give you more updates very soon.
Outside as in...where do I place it within the circuit? Do the relays just get wired in?
The reason I need the heat control is because the corn/coffee burns too fast, and too hot. I want to...
Thank you dada, ami NY e thaki. Abong apni? :)
So what you are saying is that both control/timer can only be connected to the 3Ohm heater and not the 10 Ohm one because it is attached to the fan motor?
Do you think the heating and fan circuits can be disconnected to be independent...
Yes, I got the circuit from a working product. The circuit works just fine. Don't worry if the individual components work, just wanting to know placements of NEW components, assuming the circuit works.
I just want to know (IN AN IDEAL SETTING) where would a heat control or timer go in the...
Thank you for getting back to me. Bhalo laglo shune :)
Attached is the model diagram to help clarify the appliance circuit (See first page).
1. The Button (#6 on picture) is the switch, power cord (#7) is the AC/L power source.
2.`Heating wires (#22) is the two resistors/heating coil.
3...
Thanks for your input
Thanks debjit625! (are you Bengali by any chance?)
Your circuit is very much appreciated! Please, if you would kindly...look at the attached circuit which is the appliances (coffee roaster). Courtesy of CWatters.
The M in this diagram is the fan in yours, and the 10...
Thanks for the updates, the unit needs the fan to be on when the switch is flicked on. Then the timer decides how much time the heater is going to run, and on what setting (that is what the heat control dial is for).
All I wanted to know was where exactly the timer and dial/control went in...
Hello Drakkith and debjit625
Thank you very much for your posts. I really appreciate your comments on the matter. I am not working directly with the unit, as a future designer (I am drawing sketches of new dials, timers) and an electrician is making those changes (NOT ME). I am just trying to...
Hi there!
I recently tried adding an on-off switch, a timer and a control dial (like a dimmer switch for the heating coil) to my unit. See diagrams attached. I also rewired a fan wire.
Instead of the complicated circuit diagram (see first attachment), I have shown the equipment wiring in...
Easy there, I am just asking a question since I don't know much about it. You don't have to make condescending comments about my lack of knowledge. Good day