Hello,
Looking for opinions as to what you guys think would be a fitting job title for the description below:
"Engineer solution-based designs from conception through to implementation in order to satisfy the costumer’s power requirements, as dictated by a compilation of motor schedules, panel...
Thanks for the feedback guys.
The following is information I have found relevant to my work:
Instances in which Fusible Switches would be used in lieu of Group Mounted Devices (Circuit Breakers) are feeder device amperages over 1200 A, Single Mains over 800 A, or if a Device is a Double Ended...
Hello,
Just looking into some clarrification. If a customer states that they want the following system, what is it they mean (note, it is 3-phase 4W 120/208V:
1200 A MAIN DISTRIBUTION
C/W:
1- 600 A house panel feed
2 - 100 A tenant sections
2 - 200 A tenant sections
Basically the 1200 A is...
As far as my academics were concerned, I specialized in Power and Energy, Devices, Circuits, and Sensors. I have practical experience in microwave engineering, but it was very niche in meta - DRA design.
I would be happy doing analog, power, or high frequency engineering. I am a recent graduate.
Hello,
I graduated from an accredited University in Canada with a Bachelor of Science in Electrical Engineering. I maintained Honours with Distinction for the duration of my academic career.
I am interested in working abroad, and branching from Canada. I am not sure where I want to go yet...
Hello all,
I have a question regarding professional title when working in graduate school. Upon graduating I will be registered as an Engineer-in-Training with the legislative body responsible for governing engineers in my location. 1 year of my graduate studies is suitable for work experience...
Quick question: I have a stepper motor that is 0.25 degrees per step, and so 4 steps is required for a degree. When we pump 20 steps into it, it moves 5 degrees. However, if we go to pump another 20 steps into it right after that, it does not move 5 degrees. Is it possible that residual flux is...
The behaviour of the system will primarily be governed by the poles that are close the s-axis (relative to the pole at s=-3). The solution reduces the equation to 5/(12(s^2+0.1s+0.01)), but I was certain that it should be 5/(6(s^2+0.1s+0.01)).
EDIT* I plotted it in MATLAB and determined that...
Homework Statement
I have a pretty simple question. I was going over an older exam when I encountered something that did not quite make sense to me.
If \frac{(2s+5)(-s+0.5)}{(s+3)(s^2+0.1s+0.01)},
find a low order approximation for the system.
I understand that the pole at s=-3 can be...
That certainly fixed it! It definitely was redundant and unnecessary. Thanks!
One other question: do you know a way of implementing Boolean OR in Mathcad? I want to remain in a while loop if any of 3 statements are true. This is rather easy in Matlab, but I am finding it difficult in Mathcad. I...
Homework Statement
I am writing a simple program in Mathcad for Newton's Method. The function is x^3-5*x^2+3*x+4. The root is between 0 and 3, and we want a tolerance of 0.00001. My code is the exact same as a program I made in Matlab that works, but since I am new to Mathcad, I am getting an...