Recent content by Rahul Baro

okay! thank you so much for the help :)

o okay! i understood the idea.. thanks alot!

in what cases it does not have any unit?

Flow coefficient in valves doesn't have any units. why?

Replacing a part automatically in SolidWorks assembly based on the end conditions and applications required.

Thanks

Thanks a lot.

Thanks a lot. This helps.

I did some research actually. I wanted to understand as a person who doesn't have any relation to valve or compression field.

Difference between manual drain air sets (filter regulators) and auto drain air sets?

The block one is kept stationary and only a pressure of 330 bar is applied on block 2

Its a part of an assembly process. section cut through is a part of a circular block. Hardness of block 1 is 45 and hardness of block 2 is 35. the diameter of block 1 is 242mm and diameter of block 2 is 170mm. the pressure coming on block 2 is 330bar. block 2 is stationary

I am not sure about the sectional area. what should i consider it as? and how the angle will effect here ? can you please tell

Material - SS 316