Recent content by KavaKovala

Hi jrmichler, Thank you for your reply! Just a doubt, Does the moment created by the load have any effect that must be considered? I appreciate your help.

Dear, Could you tell me if the calculations on the attachment are correct? I need to determine the force necessary to prevent the clamp from slipping. Basically the clamp is a part of rubber that I can press against the pipe wall. A load will be attached to this part of rubber. The tube is...

Baluncore and Sandy, thank you for your help. It is very clear.

Sorry, I expressed myself wrong, my english is not good, I would like to say that the length of thread in the aluminium engaged by the bolt is 15mm.

Yes, I can use helicoil, I just told you the bolt length that I will intend to use.

Beluncor, Thank you very much for your reply, I appreciate your help. The bolt length could be 15mm. I did not understand why √10 x diameter (2?)= 5.6mm. If the diameter is correct (2mm), the result should be 6,32mm or 8mm Bolt.

Hi everyone, I have a question about sizing a bolted joint. How to calculate the size of the screw? Knowing that the bolt material is 316 stainless steel and the thread material where the bolt will be bolted is 6061 aluminum. This screw will be pulled at 2000N. Thanks!