fatal error. *** cross-section tables are missing from xsdir
10001.70m
10002.70m
10003.70m
...
bad trouble in subroutine ixsdir of imcn
cannot continue with missing cross-section table(s).
is the message I am getting. I have created a link using
ln -s...
The power supplies that I was referring to are very large high power (on the order of a MegaWatt) power supplies that power the facility I am testing in. They can't be avoided. The lines from the sensor to the data acquisition system are relatively long and run past them. The facility is full of...
Hello all.
I have a data signal that I'm looking to reduce the noise in. I'm recording voltage at 12000hz and am getting high frequency noise induced by nearby power supplies in the lines that I am using. The noise amplitude is approximately .2-.3 Volts and the signal I am trying to get out...
I'm not sure that anodizing will be an option for us. We are not looking to use the needles for accupuncture. We are trying to develop a sensor that can detect the interfaces of bubbles in a high temperature flowing steam environment. We do this currently in a flowing air-gas mixture at room...
berkeman:
We have looked into the teflon coatings and it seems as though the coating is a little too thick and we cannot shape it in the desired way.
Enthalpy:
Would it be possible to anodize a needle that small? The accupuncture needles have a diameter ~120 microns. Also, how would we control...
I'm looking for some sort of dielectric coating that can be used at high temperatures. I'm working on trying to create a voltage point charge in a high temperature steam environment using a coated accupuncture needle. The goal is to be able to coat the needle thinly and uniformly, leaving only...